Course strategy · Putting

Reading greens: a simple routine that saves putts

By FIG Golf · Updated November 2026

You don't need a tour caddie to read greens better. You need the same routine on every putt, and you need to decide speed before line.

1. Read the big picture on the walk up

As you walk onto the green, look at where the whole green tilts. Where would water drain off? Most greens are built to shed water toward the front or to one side, and that overall tilt affects every putt on it.

2. Look from the low side

Stand behind the ball first, then walk to the low side of the putt, halfway between the ball and the hole. From below, slope is much easier to see than from behind. It also keeps you moving, which helps pace of play.

3. Feel the slope with your feet

While you're standing on the low side, notice which way your weight wants to fall. Your feet often pick up gentle slope your eyes miss. If it's hard to tell, it's probably close to flat. Don't invent break that isn't there.

4. Pick your speed, then your line

Break depends on speed. A firm putt breaks less; a dying putt breaks more. Decide whether you want the ball to finish about a foot past the hole, then choose the line that matches that speed. Most three-putts come from poor speed, not a poor read.

5. Pick a spot and commit

Choose the high point of the curve, where the ball should start turning toward the hole, and aim at a spot on that line a few inches in front of the ball. Then make your stroke without second-guessing. The next putt is the only one that matters.

Bonus: grain on Bermuda greens

On Bermuda grass, common in warm climates, the grass grows in a direction that can speed up or slow down putts. Shiny grass usually means you're putting down-grain (faster); dull, dark grass usually means into the grain (slower). Look at the edge of the cup too: the ragged side often shows which way the grain runs.

Practice plan: on the practice green, hit five putts from the same spot, reading each one from the low side first. Track how many finish within a foot past the hole. Speed control first, then line.

Keep reading